258
INSTRUMENTS AND CONTROLS
3-15. HEADLIGHT BEAM LE- VELER s03at
The LED headlights produce more light than conventional halogen headlights.
When the vehicle is carrying a heavy load and the headlight beams are angled upwards, the driver of an oncoming vehicle may experience glare.
To prevent this, the automatic headlight beam leveler adjusts the headlights to the optimum height automatically depending on the load the vehicle is carrying.
3-16. FRONT FOG LIGHT SWITCH( If Equipped) s03ba
CAUTION
In certain circumstances, the headlights may become misaligned, and the headlight beam leveler will not reset them to the proper angle. This may occur after transporting your vehicle on a flat-bed truck, or if the vehicle is parked and restarted on different angles. In such cases, have the headlight alignment checked by a SUBARU dealer.
NOTE
If you are driving with the headlights set to high beam and the following conditions are met, the headlight beam leveler will be aimed slightly upwards so that the light shines further ahead of your vehicle.
. The SRH function is ON.
. The high beam setting of the headlights is ON.
. The vehicle speed exceeds approximately 20 mph( 32 km / h).
When these operating conditions are no longer met, this function is canceled and the headlight beam leveler will return to the original position.
Headlight switch Fog light switch
S _ 307921-W
To turn on the front fog lights:
Turn the fog light switch to the“” position while the headlights are in either of the following conditions.
. The headlight switch is in the“” position with the low beam mode selected.
. The headlight switch is in the“ AUTO” position and the low beam headlights turn on automatically.
To turn off the front fog lights:
Turn the fog light switch back down to the“ OFF” position.
S _ 308079-W
The front fog light indicator light located on the combination meter will illuminate when the front fog lights are on.