150 KEYS AND DOORS registered key / access key fob.
NOTE
For models with“ keyless access with push-button start system”, if the access key fob battery is discharged, perform the procedure described in“ Switching Power Status” FP488. In such a case, replace the battery immediately. Refer to“ Replacing Battery of Access Key Fob” FP542.
ALARM SYSTEM SETTING s02af11
To change the setting of your vehicle’ s alarm system for activation or deactivation, do the following.
1. Disarm the alarm system. Refer to“ Disarming the System” FP149.
2. Sit in the driver’ s seat and shut all doors, the rear gate and engine hood.
3. Turn the ignition switch to the“ ON” position.
4. Hold down“” of the driver’ s power door locking switch, open the driver’ s door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows.
IF YOU HAVE ACCIDENTALLY TRIGGERED THE ALARM SYS- TEM s02af03
To stop the alarm s02af0301
Do any of the following operations:
. Press any button on the access key fob / remote transmitter.
. Turn the ignition switch to the“ ON” position( models without“ keyless access with push-button start system”).
. Turn the push-button ignition switch to the“ ACC” position( models with“ keyless access with push-button start system”).
NOTE
Only registered keys will stop the alarm. If the immobilizer transponder is not registered, the alarm will not stop.
Setting status
Combination meter
Horn
Activate AL ON Once Deactivate AL OFF Twice
NOTE
You may have the above setting change done by your SUBARU dealer.