STARTING AND OPERATING 341
7. Repeat step 5 for any additional transmitters( the system will accept up to eight transmitters).
8. The system will exit the transmitter learn mode if the key is turned to the“ LOCK”/“ OFF” position, the door is closed or after 2 minutes.
SYSTEM MAINTENANCE s07az09
NOTE For remote engine starter transceiver:
In the event that the vehicle’ s battery is replaced, discharged or disconnected, it will be necessary to start the vehicle a minimum of one time using the key prior to activating the remote engine start system. This is required to allow the vehicle electronic systems to resynchronize.
Changing the battery
s07az0901
CAUTION
. Do not let dust, oil or water get on or in the remote engine start transmitter when replacing the battery.
. Be careful not to damage the printed circuit board in the remote engine start transmitter when replacing the battery.
. Be careful not to allow children to touch the battery and any removed parts; children could swallow them.
. There is a danger of explosion if an incorrect replacement battery is used. Replace only with the same or equivalent type of battery.
. Battery should not be exposed to excessive heat such as sunshine, fire or the like.
For models with“ keyless access with push-button start system”:
Perform the procedure described in“ Replacing Battery of Access Key Fob” FP526.
For remote engine starter transceiver:
The 3-volt lithium battery( model CR- 2450) supplied in your remote engine start transmitter should last approximately one year, depending on usage. When the battery begins to weaken, you will notice a decrease in range( distance from the vehicle that your remote control operates). Follow the instructions below to change the remote engine start transmitter battery.
1. Remove the small phillips screw located on the back side lower left corner of the transmitter.
S _ 703126-MW
7
– CONTINUED –