312 INTERIOR EQUIPMENT
This is not a malfunction.
. The fan may activate when the temperature rises, but this is not a malfunction.
. Qi standard wireless charger can be used on compatible devices. However, not all Qi standard devices and compatibility are guaranteed.
. If you hear noise on the AM radio while your device is charging, you may be able to reduce the noise by changing the charging frequency. To change the charging frequency, press and hold the power switch to turn on the system. After a certain amount of time, the indicator light will flash orange twice to indicate the frequency switch.
. If the access key fob cannot be detected in the cabin, the battery cannot be charged. In addition, charging may be temporarily suspended when the remote keyless entry system is in operation, such as when opening and closing doors.
. If your mobile device does not charge even after you place it in the charging area, remove the device case and any accessories.
CERTIFICATION FOR THE WIRELESS CHARGER s06bh02
The U. S. and other FCC compliant countries:
FCC ID: ACJ932AF2201
CAUTION
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a wireless power charger, pursuant to part 18 of the FCC Rules.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio communications, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency( RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator at least 20 cm or more away from person’ s body.
NOTE
This device complies with part 15 and part 18 of the FCC Rules. Operation is subject to the following two conditions:( 1) This device may not cause harmful interference, and( 2) this device must accept any interference received, including interference that may cause undesired operation.