126 KEYS AND DOORS
Unlocking s02ap2103
Perform steps( 1) to( 5) of step 5 described in“ Registration for a PIN code”.
NOTE
. You cannot unlock by PIN Code Access in the following cases.
– When the access key fob is within
the operating ranges – When the ignition switch is in the
“ ACC” or“ ON” position. If you make an operation error during the unlocking procedure, start over with the unlocking procedure after waiting for 5 seconds or longer.
. To protect your vehicle from theft, a buzzer will sound if incorrect PIN codes are entered five times continuously. If this occurs, you cannot unlock the doors by PIN Code Access for 5 minutes.
POWER SAVING FUNCTION s02ap23
To protect the access key fob battery and the vehicle battery, the keyless access function will be disabled as follows.
. When the keyless access function and the remote keyless entry system have not been used:
( 1) 5 days after the push-button ignition switch has been turned off, communication between the antennas and the access key fob will be stopped.
( 2) 9 days after step( 1), the sensors( both lock sensor and unlock sensor) on the front passenger’ s door will be disabled.
. When the access key fob has been left in the operating range for 10 minutes or longer while all doors are locked, the keyless access function will be disabled.
Recovery from power saving mode s02ap2301
When one of the following operations is performed, the keyless access function will be recovered.
. Unlock by gripping the door handle( only when the sensors on the front passenger’ s door are not disabled) or pressing rear gate opener button on the rear gate.
. Lock or unlock by the remote keyless entry system.
. Open a door and then close it.
. Turn the push-button ignition switch to the“ ON” position.
POWER SAVING FUNCTION OF ACCESS KEY FOB s02ap26
This function stops the access key fob from receiving signals and helps minimize the battery consumption of the access key fob.
1. Press the“” button twice while holding the“” button.
2. Confirm that the LED indicator blinks 4 times to notify that the setting is complete.
LED indicator
S _ 204473-W
When the access key fob is in the power save mode, the keyless access function and push-button start system will not be available. To cancel the power save mode, press one of the buttons on the