STARTING AND OPERATING 329
ALTERNATE OPERATION METHOD s07az22
3. After step 2, immediately press and hold the lock button. The hazard warning flashers then flash three times, and the horn will honk once.
4. Approximately 3 seconds after step 3, release the lock button. The hybrid system will then start successfully.
Stopping the hybrid system s07az2203
Press and hold the lock button to stop the hybrid system with remote engine start system.
Lock button
S _ 703263-W
An access key fob can be used as the remote engine start transmitter. Operate the lock button to start or stop the hybrid system as follows.
Before starting the hybrid system s07az2201
Before using the remote engine start system to start the hybrid system, confirm the following conditions.
. The select lever is in the“ P” position.. All doors are closed.. The engine hood is closed.
. The push-button ignition switch is in the“ OFF” position.
Starting the hybrid system s07az2202
To start the hybrid system with remote engine start system, briefly press the lock button twice within 2 seconds, then press and hold the lock button for 3 seconds.
1. Press the lock button briefly. The hazard warning flashers then flash once and the buzzer chirps once.
2. Within 2 seconds, press the lock button briefly again. The hazard warning flashers then flash once again, and the buzzer chirps once again.
Remote start safety features s07az2204
For detailed information, refer to“ Remote start safety features” FP326.
ENTERING THE VEHICLE WHILE IT IS RUNNING VIA RE- MOTE START s07az24
1. Unlock the vehicle doors using the keyless access function and remote keyless entry system.
NOTE
If the vehicle’ s doors are unlocked manually using the key, the vehicle’ s alarm system will trigger( if the alarm system is armed prior to activating the remote engine start system) and the hybrid system will turn off. Perform either of the following procedures to disarm the alarm system. Refer to“ Alarm System” FP152.
– Turn the push-button ignition switch to the“ ACC” or“ ON” position.
– Press any button on the access key fob.
2. Enter the vehicle. The hybrid system will remain running provided the access key fob is present and detected by the vehicle.
3. Press the push-button ignition switch once while depressing the brake pedal before driving your vehicle. The remote engine starter transceiver( fob) will flash and beep 3 times to indicate
7
– CONTINUED –