Mirrors 249 |
|||||||
|
! Reprogramming a Single HomeLink Button
S03AP070406
To program a previously trained button , follow these steps :
1 . Press and hold the desired HomeLink button . DO NOT release the button .
2 . The indicator light will begin to slowly flash orange after 20 seconds . The HomeLink button can be released at this point . Proceed with “ Programming a New HomeLink Button ” - step 3 .
3 . If you do not complete the programming of a new device to the button , it will revert to the previously stored programming .
! Garage Door Two-Way Communication
S03AP070413
HomeLink has the capability of communicating with your garage door opener . HomeLink can receive and display “ closing ” or “ opening ” status messages from compatible garage door opener systems . At any time , HomeLink can also recall and display the last recorded status communicated by the garage door opener to indicate your garage door being “ closed ” or “ opened ”.
|
Range may be reduced by obstacles such as houses or trees . You may have to slow your vehicle speed to successfully receive the garage door opener communication .
! Programming Two-Way Communication
S03AP070414
1 Status indicators
Within five seconds after programming a new HomeLink button , both of HomeLink ’ s garage door status indicators will flash rapidly green indicating that the garage door two-way communication has been enabled . If your garage door status indicators flashed , two-way communication programming is complete .
|
online at www . HomeLink . com and www . youtube . com / HomeLinkGentex . |
! Using Two-Way Communication
S03AP070415
1 Status indicators
Recall and display ( at any time ) the last recorded garage door status message communicated to HomeLink by simultaneously pressing HomeLink buttons 1 and 2 for two seconds . HomeLink will display the last recorded status for three seconds .
|
Instruments and controls |
|||
HomeLink has the capability of receiving this communication from the garage door opener at a range up to 820 feet ( 250 m ). |
If the garage door status indicators do not flash , additional HomeLink information and programming videos can be found |
– CONTINUED – |