Mirrors 245 |
||||||||
|
3 . To adjust for compass zone variance : ( 1 ) Find your current location and zone number on the map .
( 2 ) Press and hold the “ ” switch for more than 6 seconds or until a zone number appears in the display .
( 3 ) Once the zone number appears in the display , toggle the “ ” switch again until your current location zone number appears . After you stop pressing the switch , your new zone number will be saved . Within a few seconds , the display will show a compass direction .
4 . If the vehicle ’ s magnetics have changed or if the compass appears inaccurate , recalibrate the compass . Press and hold the “ ” switch for more than 9 seconds or until a “ C ” appears in the display . Once a “ C ” appears in the display , slowly drive the vehicle in circles until compass is calibrated .
|
! HomeLink ® Wireless Control System
S03AP0704
The HomeLink ® Wireless Control System provides a convenient way to replace up to three hand-held radio-frequency remotes used to activate devices such as gate operators , garage door openers , entry door locks , security systems , and even home lighting . The below steps are generic programming instructions ; for Genie and Sommer garage door openers , please go directly to the HomeLink website . Additional information and programming videos can be found at www . HomeLink . com and www . youtube . com / HomeLinkGentex .
|
CAUTION
. Before programming HomeLink to a garage door opener or gate operator , make sure that people and objects are out of the way of the device to prevent potential harm or damage .
. When programming a garage door opener , it is advised to park outside of the garage .
. Do not use HomeLink with any garage door opener that lacks safety stop and reverse features , as required by U . S . federal safety
|
standards ( this includes any garage door opener model manufactured before April 1 , 1982 ). A garage door that cannot detect an object signaling the door to stop and reverse does not meet current U . S . federal safety standards .
. It is also recommended that a new battery be placed in the handheld remote ( garage door opener remote ) of the device for quicker and more accurate training .
. Some vehicles may require the ignition switch to be turned to the “ ON ” or “ ACC ” position for programming and / or operation of HomeLink .
. Keep the hand-held remote ( garage door opener remote ) of the device you are programming for use in other vehicles as well as for future HomeLink programming . It is also suggested that upon the sale of the vehicle , the programmed HomeLink buttons be erased for security purposes . Refer to “ Erasing HomeLink Buttons ” FP248 .
|
Instruments and controls |
||||
– CONTINUED – |