Warning and indicator 173 |
|||||
|
turn off , take your vehicle to your authorized SUBARU dealer immediately .
! If the light is blinking
S03AE0402
If the light is blinking while driving , an engine misfire condition has been detected which may damage the emission control system .
To prevent serious damage to the emission control system , you should do the following .
. Reduce vehicle speed . . Avoid hard acceleration . . Avoid steep uphill grades .
. Reduce the amount of cargo , if possible .
. Stop towing a trailer as soon as possible .
The CHECK ENGINE warning light may stop blinking and illuminate steadily after several driving trips . You should have your vehicle checked by an authorized SUBARU dealer immediately .
|
& Coolant temperature low indicator light / Coolant temperature high warning light
CAUTION
S03AE48
|
. After turning the ignition switch to the “ ON ” position , if this indicator light / warning light behaves in any of the following ways , the electrical system may be malfunctioning . Contact your SUBARU dealer immediately for an inspection .
– It remains blinking in RED .
– It remains illuminated in RED for more than 2 seconds .
– It remains blinking in RED and BLUE alternately .
. While driving , if this indicator light / warning light behaves in any of the following ways , take the specified appropriate measure listed below .
– Blinking or illuminated in RED : Safely stop the vehicle as soon as possible , and refer to the emergency steps to take in the case of engine overheating
|
. After that , have the system checked by your nearest SUBARU dealer . Refer to “ Engine overheating ” FP434 .
– Blinking in RED and BLUE alternately : The electrical system may be malfunctioning . Contact your SUBARU dealer for an inspection .
This coolant temperature low indicator light / coolant temperature high warning light has the following three functions .
. Illumination in BLUE indicates insufficient warming up of the engine .
. Blinking in RED indicates that the engine is close to overheating .
. Illumination in RED indicates overheating condition of the engine .
For a system check , this indicator light / warning light illuminates in RED for approximately 2 seconds when the ignition switch is turned to the “ ON ” position . After that , this indicator light / warning light changes to BLUE and maintains illumination in BLUE . This BLUE illuminated light turns off when the engine is warmed up sufficiently .
|
Instruments and controls |
|
– CONTINUED – |