Cleaning the interior 443 |
||||
|
. Dampness in certain parts of the vehicle remains for a long time , even though other parts of the vehicle may be dry .
. High temperatures will cause corrosion to parts of the vehicle which cannot dry quickly due to lack of proper ventilation .
& To help prevent corrosion
S10AB02
Wash the vehicle regularly to prevent corrosion of the body and suspension components . Also , wash the vehicle promptly after driving on any of the following surfaces .
. Roads that have been salted to prevent them from freezing in winter
. Mud , sand , or gravel . Coastal roads
After the winter has ended , it is recommended that the underbody be given a very thorough washing .
Before the beginning of winter , check the condition of underbody components , such as the exhaust system , fuel and brake lines , brake cables , suspension , steering system , floor pan , and fenders . If any of them are found to be rusted , they should be given an appropriate rust prevention treatment or should be replaced . Contact your SUBARU dealer to perform this kind
|
of maintenance and treatment if you need assistance .
Repair chips and scratches in the paint as soon as you find them .
Check the interior of the vehicle for water and dirt accumulation under the floor mats because that could cause corrosion . Occasionally check under the mats to make sure the area is dry .
Keep your garage dry . Do not park your vehicle in a damp , poorly ventilated garage . In such a garage , corrosion can be caused by dampness . If you wash the vehicle in the garage or put the vehicle into the garage when wet or covered with snow , that can cause dampness .
If your vehicle is operated in cold weather and / or in areas where road salts and other corrosive materials are used , the door hinges and locks , rear gate lock , and hood latch should be inspected and lubricated periodically .
|
10-3 . Cleaning the interior
S10AC
Use a soft , damp cloth to clean the climate control panel , audio equipment , instrument panel , center console , combination meter panel , and switches . ( Do not use organic solvents .)
CAUTION
Do not use sharp instruments or window cleaner containing abrasives to clean the inner surface of the rear window . They may damage the conductors printed on the window .
& Seat fabric
S10AC01
Remove loose dirt , dust or debris with a vacuum cleaner . If the dirt is caked on the fabric or hard to remove with a vacuum cleaner , use a soft brush then vacuum it .
Wipe the fabric surface with a tightly wrung cloth and dry the seat fabric thoroughly . If the fabric is still dirty , wipe using a solution of mild soap and lukewarm water then dry thoroughly .
|
If the stain does not come out , try a commercially-available fabric cleaner . Use the cleaner on a hidden place and |
Appearance care |
– CONTINUED – |