138
Alarm system
! Emergency disarming
S02AF0501
If you cannot disarm the system using the access key fob / transmitter ( i . e ., the transmitter is lost , broken or the transmitter battery is too weak ), you can disarm the system without using the access key fob / remote transmitter .
The system can be disarmed if you turn the ignition switch from the “ LOCK ”/“ OFF ” position to the “ ON ” position with a registered key / access key fob .
NOTE
For models with “ keyless access with push-button start system ”, if the access key fob battery is discharged , perform the procedure described in “ Switching power status ” FP434 . In such a case , replace the battery immediately . Refer to “ Replacing battery of access key fob ” FP490 .
& Alarm system setting
S02AF11
To change the setting of your vehicle ’ s alarm system for activation or deactivation , do the following .
1 . Disarm the alarm system . Refer to “ Disarming the system ” FP137 .
2 . Sit in the driver ’ s seat and shut all doors , the rear gate and engine hood .
3 . Turn the ignition switch to the “ ON ” position .
4 . Hold down “ ” of the driver ’ s power door locking switch , open the driver ’ s door within the following 1 second , and wait 10 seconds without releasing the switch . The setting will then be changed as follows .
Setting status
Combination meter display
Horn
Activate |
AL ON |
Once |
Deactivate |
AL OFF |
Twice |
NOTE
You may have the above setting change done by your SUBARU dealer .
& If you have accidentally triggered the alarm system
S02AF03
! To stop the alarm
S02AF0301
Do any of the following operations :
. Press any button on the access key fob / remote transmitter .
. Turn the ignition switch to the “ ON ” position ( models without “ keyless access with push-button start system ”).
. Turn the push-button ignition to the “ ACC ” position ( models with “ keyless access with push-button start system ”).
NOTE
Only registered keys will stop the alarm . If the immobilizer transponder is not registered , the alarm will not stop .
& Valet mode
S02AF06
When you choose the valet mode , the alarm system does not operate . In valet mode , the remote transmitter is used only for locking and unlocking the doors and rear gate and panic activation .
To enter the valet mode , change the setting of your vehicle ’ s alarm system to deactivation mode . Refer to “ Alarm system setting ” FP138 . The security indicator light will continue to flash once every 3 seconds , indicating that the system is in the valet mode .
To exit valet mode , change the setting of your vehicle ’ s alarm system to activation mode . Refer to “ Alarm system setting ” FP138 .