Light control switch
& Headlight flasher
CAUTION
S03AH03
. The high beam assist function uti-
lizes the stereo camera installed at the
position of the front map lights.
. For details on how to handle the
stereo camera, refer to the Owner’s
Manual supplement for the EyeSight
system.
The high beam assist function automati-
cally changes the headlight from high
beam to low beam (or vice versa).
& High/low beam change (dim-
mer)
S03AH02
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
1)
2)
High beam
Low beam
When the headlights are on high beam, the
high beam indicator light “ ” on the
combination meter is also on.
& High beam assist function (if
equipped)
S03AH07
NOTE
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on for as long as you hold
the lever.
When the headlights are on high beam, the
high beam indicator light “ ” on the
combination meter also illuminates.
When all of the following conditions are
met, the headlight will change to high
beam.
. When the vehicle speed increases to or
above 20 mph (32 km/h).
. There is no preceding or oncoming
vehicle.
. The forward area of the vehicle is dark.
. The road does not have a sharp curve.
When any of the following conditions are
met, the headlight will change to low beam.
. When the vehicle speed decreases to
or below 10 mph (16 km/h).
. When the forward area of the vehicle is
bright.
. When there is a preceding or oncoming
– CONTINUED –
If any object is placed on or near the
sensor, the sensor may not detect
the level of the ambient light cor-
rectly and the auto on/off headlights
may not operate properly.
231