Subaru Forester Manuals 2019 Forester Owner's Manual | Page 135

Remote keyless entry system & Sounding a panic alarm 129 & Replacing the battery S02AQ08 S02AQ12 Refer to “Replacing key battery” FP485. & Setting audible signal opera- tion (models without “keyless access with push-button start system”) S02AQ09 Using an electronic chirp, the system will give you an audible signal when the doors lock and unlock. If desired, you may turn the audible signal off. Perform the following steps to deactivate the audible signal. You can also use the same steps to restore the function. 1. Sit in the driver’s seat and shut all doors and the rear gate. & Replacing lost transmitters S02AQ13 If you lose a transmitter or want to purchase additional transmitters (up to four can be programmed), your transmit- ters should be reprogrammed for security reasons. For details, contact your SUBARU dealer and have the transmitters programmed into the remote keyless entry system. 2. Press and hold the “ ” of the power locking switch and pull the key out and reinsert it into the ignition switch at least 6 times within 10 seconds after Step 2. 3. Open and close the driver’s door once within 10 seconds after Step 3. The hazard warning flashers flash 3 times to indicate completion of the setting. Your SUBARU dealer can perform the above procedure for you. Also, for models with a combination meter display (color LCD), the setting can be changed using the display. For details, refer to “Vehicle Setting” FP196. & Certification for remote key- less entry system S02AQ18 ! U.S.-spec. models FCC ID: CWTB1G077 FCC ID: CWTD1G049 S02AQ1801 CAUTION FCC WARNING Changes or modifications not ex- pressly approved by the party re- sponsible for compliance could void the user’s authority to operate the equipment. – CONTINUED – To activate the alarm, press the “PANIC” button once. The horn will sound and the hazard warning flashers will flash. To deactivate the panic alarm, press any button on the remote transmitter. Unless a button on the remote transmitter is pressed, the alarm will be deactivated after approximately 30 seconds.