Seat, seatbelt and SRS airbags/Seatbelts
“CENTER” on the left-hand side until it
clicks.
2. Pass the seatbelt through the belt
guide.
3. After confirming that the webbing is not
twisted, insert the connector (tongue)
attached at the webbing end into the
buckle on the right-hand side until a click
is heard.
. If the belt stops before reaching the
buckle, return the belt slightly and pull
it out more slowly.
. If the belt still cannot be unlocked,
let the belt retract slightly after giving it
a strong pull, then pull it out slowly
again.
1-23
4. After fastening the seatbelt, make sure
that the “ ” mark on the connector
(tongue) and the “ ” mark on the buckle
face outwards.
6. To make the lap part tight, pull up on
the shoulder belt.
7. Place the lap belt as low as possible
on your hips, not on your waist.
5. Insert the center seatbelt tongue plate
into the center seatbelt buckle marked
– CONTINUED –