Instruments and controls/Wiper and washer
shield washer for at least 1 second so
that washer solution will be sprinkled
all over the windshield or rear window.
. Grease, wax, insects or other mate-
rial on the windshield or the wiper
blade rubbers results in jerky wiper
operation and streaking on the glass. If
you cannot remove those streaks after
operating the washer or if the wiper
operation is jerky, clean the outer sur-
face of the windshield or rear window
and the wiper blade rubbers using a
sponge or soft cloth with a neutral
detergent or mild-abrasive cleaner.
After cleaning, rinse the window glass
and wiper blade rubbers with clean
water. The glass is clean if no beads
form on the glass when you rinse with
water.
. If you cannot eliminate the streaking
even after following this procedure,
replace the wiper blades or wiper blade
rubbers with new ones. For replace-
ment instructions, refer to “Replace-
ment of wiper blades” F11-32.
& Windshield wiper and washer
switches
The wiper operates only when the ignition
switch is in the “ON” position.
3-105
For a single wipe of the wipers, push the
lever up. The wipers operate until you
release the lever.
! Wiper intermittent time control
! Windshield wipers
: Mist (for a single wipe)
: Off
When the wiper switch is in the “ ”
position, turn the dial to adjust the operat-
ing interval of the wiper. The operating
interval can be adjusted in several steps
from the shortest interval to the longest.
: Intermittent
: Low speed
: High speed
To turn the wipers on, push the wiper
control lever down.
To turn the wipers off, return the lever to
the “ ” position.
– CONTINUED –