3-90
Instruments and controls/Multi function display
notification will be displayed. In this case,
perform the setting procedure again.
6. Select “Set” by operating the “ ”
switch, and confirm the setting by pushing
button.
the
! Approaching time setting
The setting procedure is the same as
“Leaving time setting” F3-89, but select
the “Approaching time set” item in step 3.
& Initialize
Items that have been set to your pre-
ference can be initialized. To select an
initialization menu, operate the “ ” or “ ”
switch as follows.
! Preparation for initialization
7. The system will notify you that the
setting is complete.
If the setting is not available, the following
1. Turn the ignition switch to the “ON”
position.
button to show
2. Push and hold the
the selection screen.
3. After the selection screen is displayed,
operate the “ ” or “ ” switch to show the
button.
“Initialize” item. Then, push the
! Reset to factory default settings
1. Perform the preparation steps accord-
ing to “Preparation for initialization” F3-
90.