Seat, seatbelt and SRS airbags/Front seats
A chirp sounds and the seat moves to the
registered position. When the seat moves
to the registered position, a chirp will
sound.
! Retrieval of the seat position
registered with access key
1. Hold the registered access key.
NOTE
. If a new position is registered for the
same button, the previously registered
seat position is deleted.
. If the vehicle battery is removed, the
registered seat position is not deleted.
. When the button “1” or “2” is
pressed within 45 seconds after the
driver’s door is opened, the registered
seat position can be retrieved even if
the ignition switch is in the “LOCK” or
“OFF” position.
1-7
(2) Press the “ ” button on the
access key or touch the door lock
sensor to lock the doors.
(3) Perform the prior procedures
again.
. If the keyless access function is
disabled, the seat position cannot be
retrieved by gripping the driver’s door
handle. However, the seat position can
still be retrieved by pressing the “ ”
button on the access key. For information about how to enable/disable the
keyless access function, refer to “Disabling keyless access function” F2-17.
. If a new position is registered for the
same access key, the previously registered seat position is deleted.
2. Unlock the driver’s door by pressing
the “ ” button or gripping the door handle.
3. Open the driver’s door.
! Clearing the registered seat
position with access key
A chirp sounds and the seat moves to the
registered position. When the seat moves
to the registered position, a chirp will
sound.
1. Close the driver’s door.
2. While holding the access key and
pressing the “SET” button, press the “ ”
button on the access key.
NOTE
A chirp will sound, and the registered seat
position will be cleared.
. If the registered seat position cannot
be retrieved after performing the previous procedures, try the following
procedures.
(1) Press the “SET” button on the
driver’s door.
– CONTINUED –