Instruments and controls / Light control switch
3-95
! Sensor for the auto on / off headlights( if equipped)
The sensor is on the instrument panel as shown in the illustration.
CAUTION
If any object is placed on or near the sensor, the sensor may not detect the level of the ambient light correctly and the auto on / off headlights may not operate properly.
& High / low beam change( dimmer)
To change from low beam to high beam, push the turn signal lever forward. When the headlights are on high beam, the high beam indicator light“” on the combination meter is also on.
To switch back to low beam, pull the lever back to the center position.
! High beam assist function( if equipped)
NOTE
. The high beam assist function utilizes the stereo camera installed at the position of the front map lights.. For details on how to handle the stereo camera, refer to the Owner’ s Manual supplement for the EyeSight system.
The high beam assist function automatically changes the headlight from high beam to low beam( or vice versa).
When all of the following conditions are met, the headlight will change to high beam.
. When the vehicle speed increases to or above 20 mph( 32 km / h).
. There is no preceding or oncoming vehicle.
. The forward area of the vehicle is dark.. The road does not have a sharp curve.
When any of the following conditions is met, the headlight will change to low beam.
. When the vehicle speed decreases to or below 10 mph( 16 km / h).
. When the forward area of the vehicle is bright.
. When there is a preceding or oncoming vehicle.
. When the EyeSight system is malfunctioning or is temporarily stopped.
NOTE
The factory setting( default setting) for this function is set as“ operational”. This setting can be changed to OFF( non-operation) at SUBARU dealers.
– CONTINUED –