Instruments and controls/Multi information display (models with type B combination meter)
By operating the “ ” or “ ” switch on the
steering wheel, you can select the menu.
Pull the “ /SET” switch to enter the
selected menu.
NOTE
If you enter the “Go Back” menu, the
system will return to the previous
screen.
! Screen Settings
After entering the “Screen Settings” menu,
select one of the following menus.
! Welcome Good-bye Screen
The welcome screen/good-bye screens
can be activated or deactivated. Select
“On” to activate the screens. Select “Off”
to deactivate the screens.
! Gauge Initial Movement
The movement of the meter needles and
gauge needles that occurs when the
ignition switch is turned to the “ON”
position can be activated or deactivated.
Select “On” to activate. Select “Off” to
deactivate.
! Languages
Operate the “ ” or “ ” switch on the
steering wheel to display the preferred
language. Then pull the “ /SET” switch to
select the displayed language.
! EyeSight (models with EyeSight
system)
NOTE
For models with the EyeSight system,
refer to the Owner’s Manual supplement for the EyeSight system.
After entering the “EyeSight” menu, select
one of the following menus.
! Warning Volume
The volume of the warning buzzer that
sounds when the EyeSight system is in
use can be set in 3 stages (“Max”, “Mid”
and “Min”).
! Lead Vehicle Acquisition Sound
When adaptive cruise control is used, the
buzzer that sounds if a vehicle is detected
in front or if detection is not possible can
be activated or deactivated. Select “On” to
activate the buzzer. Select “Off” to deactivate the buzzer.
! Lead Vehicle Moving Monitor
Function
When the lead vehicle moving monitor
function is in operation, the buzzer that
sounds if a vehicle in front has started can
be activated or deactivated. Select “On” to
activate the buzzer. Select “Off” to deactivate the buzzer.
3-43
! BSD/RCTA (if equipped)
After entering the “BSD/RCTA” menu,
select the “Warning Volume” menu. You
can set the volume of the warning buzzer
for RCTA (Rear Cross Traffic Alert). You
can select “Max”, “Mid”, “Min” or “Off”.
! RAB (if equipped)
NOTE
For models with the RAB (Reverse
Automatic Braking) system, refer to
“Reverse Automatic Braking System”
F7-66.
After entering the “RAB” menu, select one
of the following menus.
! Warning Volume
The volume of the warning sound that is
activated when the RAB (Reverse Automatic Braking) system is in operation can
be set in 3 stages (“Max”, “Mid” and “Min”).
! Sonar Audible Alarm
The RAB (Reverse Automatic Braking)
system is equipped with a function that
emits a warning sound when the system
operates. The function can be activated or
deactivated. Select “On” to set the warning sound to active. Select “Off” to set the
warning sound to inactive.
– CONTINUED –