3-38
Instruments and controls/Information display (Mexico–spec. models)
! X-mode indicator (if
equipped)
For type A combination meter
1) Trip knob
Pressing the trip knob toggles the display
between the average vehicle speed corresponding to the A trip meter display and
the average vehicle speed corresponding
to the B trip meter display.
When either of the trip meter displays is
reset, the corresponding average vehicle
speed value is also reset.
NOTE
When either trip meter display is reset,
the average vehicle speed corresponding to that trip meter display is not
shown until the vehicle has subsequently covered a distance of 1 mile
(or 1 km).
This indicator will be shown while the Xmode is activated. It will turn off when the
X-mode is deactivated.
! Turn off display of driving information display
The driving information display can be
turned off.
To turn off the display, turn the ignition
switch to the “LOCK”/“OFF” position and
press the “+” button adjacent to the clock
display for approximately 5 seconds.
Then, the driving information display and
the clock display will blink for 3 seconds to
notify you that the driving information
display has been turned off.
To restore the driving information display,
once again press the “+” button for
approximately 5 seconds.
information display, the display will
automatically turn on when the battery
voltage i s disconnected and then reconnected for battery replacement or
fuse replacement.
& Clock
If your vehicle is equipped with the
genuine SUBARU navigation system, the
clock of navigation system must be set
separately.
NOTE
. The initial display setting of the
driving information display has been
set to operational at the time of shipment from the factory.
. The average fuel consumption and
average vehicle speed are calculated
even while the driving information display is not displayed.
. Even if you turn off the driving
To adjust the time shown by the clock,
press the “+” button or “−” button. If you
press the “+” button, the indicated time will
change in one-minute increments. If you
press the “−” button, the indicated time will
change in one-minute decrements. If you
keep the button pressed, the rate at which
the indicated time changes will speed up.