3-32
Instruments and controls/Warning and indicator lights
& Turn signal indicator
lights
These lights show the operation of the turn
signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, the turn signal bulb may be burned
out. Replace the bulb as soon as possible.
Refer to “Replacing bulbs” F11-39.
& High beam indicator
light
Select lever/gear position indicator (type
B)
1) Upshift indicator
2) Downshift indicator
3) Select lever/gear position indicator
This indicator shows the position of the
select lever.
For models with manual mode, when the
manual mode is selected, the gear position indicator (which shows the current
gear selection) and the upshift/downshift
indicator light up. Refer to “Continuously
variable transmission” F7-24.
For models with SI-DRIVE, the upshift/
downshift indicators are switched off while
the Sport Sharp (S#) mode is selected.
This light shows that the headlights are in
the high beam mode.
This indicator light also illuminates when
the headlight flasher is operated.
& High beam assist indi-
cator light (if equipped)
CAUTION
If the CHECK ENGINE warning light/
malfunction indicator light illuminates, the cruise control indicator
light flashes at the same time. At
this time, avoid driving at high
speed and have your vehicle inspected at a SUBARU dealer as
soon as possible.
& Cruise control set indicator light (if
equipped)
This light illuminates when vehicle speed
has been set to use the cruise control
function. Refer to “To set cruise control”
F7-53.
This light illuminates when the high beam
assist function is activated. For details
about the high beam assist function, refer
to “High beam assist function” F3-95.
& Automatic headlight
& Cruise control indica-
This light illuminates when the automatic
headlight beam leveler does not operate
normally.
If this light illuminates while driving or does
not turn off approximately 3 seconds after
turning the ignition switch to the “ON”
position, have your vehicle inspected at
your SUBARU dealer.
tor light (if equipped)
This light illuminates when the cruise
control main button is pressed to activate
the cruise control function. For details,
refer to “To set cruise control” F7-53.
beam leveler warning
light (if equipped)