Keys and doors / Rear gate
2-43
Memory switch status 1) ON status 2) OFF status
Your desired rear gate height can be registered.
Registration of the rear gate height:
To register the rear gate height, perform the following procedures while the ignition switch is in the“ LOCK”/“ OFF” position.
1. Press the memory switch to select the“ ON” status.
Rear gate opener button
2. Press and hold the rear gate opener button located above the license plate. After the latch releases, let go of the button and raise the rear gate to the desired height manually.
Power rear gate button on the inside edge of the rear gate
3. With the rear gate at the desired height, press and hold the power rear gate button on the inside edge of the rear gate until an electronic chirp is heard and the hazard warning flashers flash three times. The electronic chirp and the flashing hazard warning flashers confirm the selected rear gate height has been registered.
4. Close the rear gate manually( without using the power rear gate).
NOTE
. To change the registered height, perform the registering procedure again.. It is possible to register the height
– CONTINUED –