Keys and doors / Alarm system 2-31
& Tripped sensor identification
The security indicator light flashes when the alarm system has been triggered. Also, the number of flashes indicates the location of unauthorized intrusion or the severity of impact on the vehicle.
When the ignition switch is turned to the“ ON” position, the indicator light will light for 1 second and then flash as follows.
. When a door or rear gate was opened: 5 times
. When a strong impact or multiple impacts were sensed: twice( only models with shock sensors( dealer option))
. When a light impact was sensed: once( only models with shock sensors( dealer option))
NOTE
Any of the above indicator light flashings will recur each time the ignition switch is turned to the“ ON” position. Rearming the alarm system cancels the flashing.
& Shock sensors( dealer option)
The shock sensors trigger the alarm system when they sense impacts applied to the vehicle and when any of their electric wires are cut. The alarm system causes the horn to sound and the hazard warning flashers to flash for a short time when the sensed impact is weak, but it warns of a strong impact or multiple impacts by sounding the horn and flashing the hazard warning flashers, both lasting approximately 30 seconds.
If you desire, your SUBARU dealer can connect them and set them for activation or deactivation.
NOTE
. The shock sensors are not always able to sense impacts caused by breaking in, and cannot sense an impact that does not cause vibration( such as breaking the glass using a rescue hammer).. The shock sensors may sense vibration as indicated in the following examples and trigger the alarm system. Select the settings of the alarm system and shock sensors appropriately depending on where you usually park your vehicle.
Examples: – Vibration from a construction site – Vibration in a multistory car park – Vibration from trains. You can have the sensitivity of the shock sensors adjusted to your preference by your SUBARU dealer.