Lane Keep Assist
Press the
(Lane Keep Assist) switch once again to turn it off, and “
Assist indicator) is turned off on the EyeSight display area.
” (Lane Keep
The Lane Departure Prevention Function goes into the standby status, and the lane indicator illuminates when all of the following conditions are met.
x The vehicle speed is between approximately 40 MPH (65 km/h) and 90 MPH (145 km/h).
x The system is detecting the lane markings.
x The driver is holding the steering wheel.
x When driving on a road that has a lane width that is between approximately 10 ft (3 m)
and 15 ft (4.5 m).
x When driving on a straight road or gentle curve.
x When driving near the center of a lane.
When the vehicle is about to depart from the lane, Lane Departure Prevention Function
starts to operate and “
” (Lane Keep Assist indicator) illuminates in green while it is
operating.
Turned on
E
Standby status
E
F
In operation
F
(white)
Lane Keep
Assist
indicator
(white)
miles
E
F
miles
(green)
miles
S02308
NOTE
x If you just lightly put your hands on the steering wheel for a certain period
of time or if you do not operate the steering wheel, the function will automatically be canceled. (“
” (Lane Keep Assist indicator) illuminates in
white again.)
x Lane Departure Prevention Function operates when the system determines that the vehicle will depart from the lane if you continue to drive in
the same manner. Therefore, it operates at an earlier timing than Lane
Departure Warning ( Refer to page 68) (it may depend on the surrounding environment and road condition).
x The lane indicator in the standby status and in operation may illuminate
only on the left side or right side.
59