Seat, seatbelt and SRS airbags/Child restraint systems
the rear seat window-side seating positions. For each window-side seating position, two lower anchorages are provided.
Each lower anchorage is located behind
the cover of the seatback bottom.
place. Otherwise, in an accident,
serious injury or death could result.
1. Shake the seatback slightly to confirm
that it is securely locked into place.
– It is possible to check whether the
seatback is locked visually. If the
seatback is locked into place, the red
colored unlocking marker which is
attached to the bottom of the lock
release knob is invisible. For details,
refer to “Folding down the rear seatback” F1-10.
The tether anchorages (upper anchorages) are provided at the locations
shown in the above illustration. For details, refer to “Top tether anchorages” F137.
Before installing a child restraint
system, be sure to confirm that the
seatback is securely locked into
Remove the covers and locate the lower
anchorages (bars).
3. Remove the rear seat head restraint.
For details, refer to “Head restraint adjustment” F1-9.
CAUTION
To install a child restraint system using
lower and tether anchorages, perform the
following procedure.
WARNING
1-35
2. You will find marks “ ” at the bottom of
the rear seat seatbacks. These marks
indicate the positions of the lower anchorages (bars).
Store the head restraint that has
been removed in the cargo area.
Avoid placing the head restraint in
the passenger compartment to prevent it from being thrown around in
the passenger compartment in a
sudden stop or a sharp turn.
4. For models with rear seat reclining
mechanism, adjust the seatback to the
upright position.
– CONTINUED –