Maintenance and service/Replacing bulbs
sembly rearward and remove it from the
vehicle.
7. Tighten the upper and lower screws.
& License plate light
1)
2)
1)
2)
3)
4)
Stop/tail light (This light is also used as
the rear side marker light.)
Backup light
Rear turn signal light
Tail light
3. Remove the bulb socket from the rear
combination light assembly by turning it
counterclockwise.
4. Pull the bulb out of the bulb socket and
replace it with a new one.
5. Set the bulb socket into the rear
combination light assembly and turn it
clockwise until it locks.
11-43
Guide pins
Clip
6. Put the rear combination light assembly into place while aligning the 2 guide
pins and a catch with the guide holes and
a clip on the vehicle.
1. To remove the right-hand side license
plate light cover, insert a finger into the
right side of the cover, and then press
once to the left and pull it out. To remove
the left-hand side license plate light cover,
insert a finger into the left side of the
cover, and then press once to the right
and pull it out.
– CONTINUED –