In case of emergency/Access key – if access key does not operate properly
Access key – if access key
does not operate properly
& Locking and unlocking
9-17
& Switching power
1. Apply the parking brake.
2. Shift the select lever into the “P”
position.
3. Depress the brake pedal.
CAUTION
Keep metallic objects, magnetic
sources and signal transmitters
away from the area between the
access key and the push-button
ignition switch. They may interfere
with the communication between
the access key and the push-button
ignition switch.
If the locking/unlocking procedures, power
switch procedures or engine start procedures cannot be operated because of
strong radio signals in the surrounding
area or a low battery condition of the
access key, perform the following procedure. When the battery of the access key
is discharged, replace it with a new one.
Refer to “Replacing battery of access key”
F11-45.
1)
2)
Release button
Mechanical key
While pressing the release button of the
access key, take out the mechanical key.
Lock or unlock the driver’s door with the
mechanical key according to the procedure described in “Locking and unlocking
from the outside” F2-5.
NOTE
After locking or unlocking, be sure to
reinsert the mechanical key into the
access key.
4. Hold the access key with the buttons
facing you, and touch the push-button
ignition switch with it.
When the communication between the
access key and the vehicle is completed,
a chime (ding) will sound. At the same
time, the status of the push-button ignition
switch changes to either of the following.
. When the keyless access with pushbutton start system is deactivated:
“ACC”
. Under other conditions: “ON”
5. When the keyless access with push– CONTINUED –