Instruments and controls/Multi function display
3-81
notification will be displayed. In this case,
perform the setting procedure again.
4. The current setting will be displayed.
Pull the “ /SET” switch toward you to
enter the selection mode.
6. Select “Set” by operating the “ ”
switch, and confirm the setting by pulling
the “ /SET” switch toward you.
! Approaching time setting
The setting procedure is the same as
“Leaving time setting” F3-80, but select
the “Approaching time set” item in step 3.
& Initialize
Items that have been set to your preference can be initialized. To select an
initialization menu, operate the “ ” or “ ”
switch as follows.
! Preparation for initialization
5. Select the preferred setting by operating the “ ” or “ ” switch, and then pull
the “ /SET” switch toward you.
7. The system will notify you that the
setting is complete.
If the setting is not available, the following
1. Turn the ignition switch to the “ON”
position.
2. Pull and hold the “ /SET” switch
toward you to show the selection screen.
– CONTINUED –