Instruments and controls/Multi function display
3. The current setting will be displayed.
Pull the “ /SET” switch toward you to
enter the selection mode.
3-77
5. Select “Set” by operating the “ ”
switch, and confirm the setting by pulling
the “ /SET” switch toward you.
! Keyless access setting (models
with “keyless access with pushbutton start system”)
4. Select the preferred setting by operating the “ ” or “ ” switch. Then pull the
“ /SET” switch toward you.
6. The system will notify you that the
setting is complete.
If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
! Preparation for keyless access
settings
1. Perform the preparation steps according to “Preparation for car settings” F3-72.
– CONTINUED –