Subaru Forester Manuals 2016 Forester EyeSight® Manual | Seite 88

Troubleshooting
Cruise control cannot be set.
Did you remember to press the
(CRUISE) switch?
If you have not pressed the
(CRUISE) switch, the
Control) indicator will not be shown.

(Adaptive Cruise

Is EyeSight operation temporarily stopped?
When EyeSight is temporarily stopped, one of the EyeSight temporary stop indicators (“E1”, “E2” or “E3”) will be displayed on the data display.
Set cruise control again after the reason for the temporary stop has been corrected.
Is the [READY] indicator displayed?
When Adaptive Cruise Control is being used Cruise control cannot be set when
the [READY] indicator is not displayed. Set cruise control when the [READY] indicator is displayed.

The [READY] indicator is not displayed.
Have you selected Conventional Cruise Control?
With Conventional Cruise Control,
(following distance setting) will not be displayed on the meter display.
Are the requirements for setting cruise control met?
In any of the following cases, the [READY] indicator will not be displayed.
The brake pedal is depressed.
The vehicle speed is over 90 MPH (145 km/h). (When no vehicle in front
has been detected, the speed is between approximately 25 MPH (40 km/h)
and 90 MPH (145 km/h).)
The meter display indicates that the shift position indicator is in any position other than D . (The select lever or paddle shift switches are manually
operated.)
The driver’s seatbelt is unfastened.
Any door of the driver’s, front passenger’s and rear doors is opened.
The parking brake is applied (when the brake warning light is illuminated).
The vehicle is on a steep grade.
The steering wheel is turned significantly in either direction.
Vehicle Dynamics Control is off, or is turned off.
The X-mode is turned on. (The X-mode indicator illuminates.)

84