11-34
Maintenance and service/Replacement of wiper blades
carefully return the wiper arms
on the windshield by hand. You
should not return the wiper arms
to the windshield only by the
return spring. Otherwise, the wiper arms may be deformed and/
or the windshield surface may be
scratched.
& Windshield wiper blade assembly
& Windshield wiper blade rubber
1. Raise the wiper arm off the windshield.
If you cannot eliminate the streaking even
after following this method, replace the
wiper blades using the following procedures.
1)
1)
2)
Open the cover
Pull down the wiper blade
2. Remove the wiper blade assembly by
opening the cover and pulling it down in
the direction shown in the illustration.
3. Install the wiper blade assembly to the
wiper arm. Make sure that it locks in place.
4. Hold the wiper arm by hand and slowly
lower it in position.
Support
1. Grasp the locked end of the blade
rubber assembly and pull it firmly until the
stoppers on the rubber are free of the
support.