3-102
Instruments and controls/Mirrors
NOTE
Some gate operators and garage door
openers may require you to replace
this programming step 4 with procedures in “Programming for entrance
gates and garage door openers in
Canada” F3-103.
5. Hold down both buttons until the
HomeLink® indicator light flashes, first
slowly then rapidly. When the indicator
light flashes rapidly, both buttons may be
released. (The rapidly flashing light indicates successful programming of the new
frequency signal.)
6. Press and hold the programmed button and check the HomeLink® indicator
light. If the indicator light stays on continuously, your garage door should activate and the programming is completed.
If the indicator light flashes rapidly for 2
seconds and then stays on continuously,
your garage door opener may be protected by a rolling code feature. In this
case you need to perform the additional
steps that are described in “Programming
rolling-code-protected garage door openers in the U.S.A.” F3-102.
! Programming rolling-code-protected garage door openers in
the U.S.A.
If your garage door opener has a rolling
code feature, program the HomeLink®
Wireless Control System for it by following
steps 1 through 5 in “Garage door opener
programming in the U.S.A.” F3-101. Then
continue with the following steps.
refer to your garage door opener’s instruction manual.
NOTE
The assistance of a second person
may make the programming quicker
and easier.
1)
Training button
2. Press the training button on the
garage door opener motor head unit
(which activates the “training light” on the
unit). Proceed to step 3 within 30 seconds.
3. Inside the vehicle, firmly press, hold for
2 seconds and release the HomeLink®
button that was programmed in the previous section. Press and release the
button a second time to complete the
programming procedure.
1. Locate the training button on the
garage door opener motor head unit.
The exact location and color of the button
may vary by brand of garage door opener.
If it is difficult to locate the training button,