2-24
Keys and doors/Alarm system
tically lock.
& Disarming the system
Security indicator light
6. Carry the access key and touch the
door lock sensor. All doors (and the rear
gate) will lock, an electronic chirp will
sound once, the hazard warning flashers
will flash once, and the security indicator
light will start flashing rapidly. After rapid
flashing for 30 seconds (standby time), the
security indicator light will then flash
slowly (twice approximately every 2 seconds), indicating that the system has been
armed for surveillance.
If any of the doors or the rear gate is not
fully closed, an electronic chirp sounds
five times, the hazard warning flashers
flash five times to alert you that the doors
(or the rear gate) are not properly closed.
When you close the door, the system will
automatically arm and doors will automa-
Perform either of the following procedures.
. Briefly press the disarm button (for less
than 2 seconds) on the access key/remote
transmitter.
. Carry the access key and perform
either of the following procedures (models
with “keyless access with push-button
start system”).
– Grip the front door handle.
– Press the rear gate opener button.
The following door(s) will unlock, an
electronic chirp will sound twice and the
hazard warning flashers will flash twice.
. Driver’s door: when either of the
following procedures is performed
– Press the disarm button on the
access key/remote transmitter briefly
(for less than 2 seconds).
– Grip the driver’s door handle (models with “keyless access with pushbutton start system”).
. Rear gate: when pressing the rear gate
opener button (models with “keyless access with push-button start system”)
. All doors: when gripping the front
passenger’s door handle (models with
“keyless access with push-button start
system”)
The flashing of the security indicator light
will then change slowly (once approximately every 3 seconds from twice approximately every 2 seconds), indicating
that the alarm system has been disarmed.
To unlock all other doors and the rear
gate, briefly press the disarm button a
second time within 5 seconds.
! Emergency disarming
If you cannot disarm the system using the
access key/transmitter (i.e. the transmitter
is lost, broken or the transmitter battery is
too weak), you can disarm the system
without using the access key/remote
transmitter.
The system can be disarmed if you turn
the ignition switch from the “LOCK”/“OFF”
to the “ON” position with a registered key/
access key.
NOTE
For models with “keyless access with
push-button start system”, if the access key battery is discharged, perform
the procedure described in “Switching
power” F9-17. In such a case, replace
the battery immediately. Refer to “Replacing access key battery” F11-45.