11-42
Maintenance and service/Battery replacement
2. Turn the bulb socket counterclockwise
and pull out the socket.
3. Pull the bulb out of the socket.
4. Install a new bulb.
5. Reinstall the bulb socket and the
license plate light cover.
& Other bulbs
It may be difficult to replace the bulbs.
Have the bulbs replaced by your
SUBARU dealer if necessary.
Maintenance and service/Battery replacement
Battery replacement
The access key / transmitter battery may
be discharged under the following conditions.
. The operation of the keyless access
function is unstable
. The operating distance of the remote
keyless entry system is unstable
. The transmitter does not operate properly when used within the standard distance
Replace the battery with a new one.
CAUTION
. Do not let dust, oil or water get on
or in the access key/transmitter
when replacing battery.
. Be careful not to damage the
printed circuit board in the access key/transmitter when replacing the battery.
. Be careful not to allow children to
touch the battery and any removed parts; children could
swallow them.
. There is a danger of an explosion
if the battery is incorrectly replaced. Replace only with the
same or equivalent type of the
battery.
. Batteries should not be exposed
to excessive heat such as bright
sunlight, fire or the like.
& Replacing access key battery
11-43
illustration. Attach the cover firmly.
Battery: Button battery CR1632
& Replacing transmitter battery
NOTE
. Replace only with the same or
equivalent type of battery recommended by the manufacturer.
. Dispose of used batteries according
to local laws.
. Mount the battery in the correct
orientation to prevent fluid leakage.
Be careful not to bend the terminals. It
may result in a malfunction.
. It is recommended that the battery
should be replaced by a SUBARU
dealer.
. Use a new battery.
. After replacing the battery, confirm
that the access key/transmitter functions properly.
1. Pull out the mechanical key.
2. Insert the key into the gap and turn it
clockwise to remove the cover.
3. Wrap a flat-head screwdriver with
insulating tape, and insert it between the
battery and the board. Then pry it out from
the board.
1. Open the key head using a flat-head
screwdriver.
4. Insert a new battery with its positive (+)
side facing upward as shown in the
– CONTINUED –