11-40
Maintenance and service/Replacing bulbs
Maintenance and service/Replacing bulbs
& Rear combination lights
Parking light
1. Remove the electrical connector from
the clip.
Parking light
2. Turn the socket counterclockwise and
pull it out.
3. Pull out the bulb from the socket and
replace the bulb with a new one.
1. Using a Phillips screwdriver, remove
the upper and lower screws that secure
the rear combination light assembly.
& Parking light
& Front fog light (if equipped)
It may be difficult to replace the bulbs.
Have the bulbs replaced by your SUBARU
dealer if necessary.
Front turn signal light
Front side marker light
7. Tighten the upper and lower screws.
& License plate light
1)
2)
1)
2)
3)
4)
Stop/tail light (This light is also used as
the rear side marker light.)
Backup light
Rear turn signal light
Tail light
Guide pins
Clip
6. Put the rear combination light assembly into place while aligning the 2 guide
pins and a catch with the guide holes and
a clip on the vehicle.
1. Insert a finger into the right side of the
license plate light cover, then press once
to the left and pull out to remove the cover.
3. Remove the bulb socket from the rear
combination light assembly by turning it
counterclockwise.
4. Pull the bulb out of the bulb socket and
replace it with a new one.
5. Set the bulb socket into the rear
combination light assembly and turn it
clockwise until it locks.
It may be difficult to replace the bulbs.
Have the bulbs replaced by your SUBARU
dealer if necessary.
1)
2)
sembly rearward and remove it from the
vehicle.
11-41
2. Slide the rear combination light as– CONTINUED –