Keys and doors/Rear gate
2-35
Registration of the rear gate height:
To register the rear gate height, perform
the following procedures while the ignition
switch is in the “LOCK”/“OFF” position.
1. Press the memory switch to select the
“ON” status.
Memory switch (Canada-spec. models)
Power rear gate button on the inside edge
of the rear gate
Rear gate opener button
2. Press and hold the rear gate opener
button located above the license plate.
After the latch releases, let go of the
button and raise the rear gate to the
desired height manually.
Memory switch status
1) ON status
2) OFF status
Your desired rear gate height can be
registered.
3. With the rear gate at the desired
height, press and hold the power rear
gate button on the inside edge of the rear
gate until an electronic chirp is heard and
the hazard warning flashers flash three
times. The electronic chirp and the flashing hazard warning flashers confirm the
selected rear gate height has been registered.
4. Close the rear gate manually (without
using the power rear gate).
NOTE
. To change the registered height,
perform the registering procedure
again.
. It is possible to register the height
– CONTINUED –