3-30
Instruments and controls
& High/low beam change (dimmer)
& Headlight flasher
& Daytime running light system
(if equipped)
WARNING
The brightness of the illumination of
the high beam headlights is reduced
by the daytime running light system.
The light switch must always be
turned to the “ ” position when it
is dark outside.
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light “ ” on the combination meter also illuminates.
To switch back to low beam, pull the lever
back to the center position.
To flash the headlights, pull the lever
toward you. The high beam will remain
on as long as you hold the lever. The
headlight flasher works even though the
light switch is in the “OFF” position.
When the headlights are on high beam,
the high beam indicator light “ ” on the
combination meter also illuminates.
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
The high beam headlights will automatically illuminate at reduced brightness
when the engine has started, under the
following conditions:
. The select lever is in a position other
than the “P” position (AT models).
. The parking brake is fully released.
. The light switch is in the “OFF” or “
”
position.
NOTE
When the light switch is in the “
”
position, the front side marker lights,
tail lights and license plate lights are
also illuminated.