3-28
Instruments and controls
NOTE
NOTE
The indicated values vary in accordance with changes in the vehicle’s
running conditions. Also, the indicated
values may differ slightly from the
actual values and should thus be
treated only as a guide.
. The indicated values vary in accordance with changes in the vehicle’s
running conditions. Also, the indicated
values may differ slightly from the
actual values and should thus be
treated only as a guide.
. After either trip meter display is
reset, the average fuel consumption
corresponding to that trip meter display is not shown until the vehicle has
subsequently covered a distance of 1
mile (or 1 km).
& Average fuel consumption
& To turn off fuel consumption
indicator display
1)
2)
U.S.-spec. models
Except U.S.-spec. models
This display shows the average rate of
fuel consumption since the trip meter was
last reset.
When either of the trip meter displays is
reset, the corresponding average fuel
consumption value is also reset.
The fuel consumption indicator display
can be turned off.
To turn off this display, turn the ignition
switch to the “LOCK” position and press
the “+” button adjacent to the information
display for approximately 5 seconds. The
information display and the clock display
will blink for 3 seconds and then the fuel
consumption display will turn off.
To restore the indicator, once again press
the “+” button for approximately 5 seconds.
NOTE
. The initial display setting of the fuel
consumption indicator of your vehicle
has been set to operational at the time
of shipment from the factory.
. The average fuel consumption is
calculated even while the indicator is
not displayed.
. Even if you turn off the fuel consumption indicator, the fuel consumption indicator will automatically turn on
when the battery voltage is stopped
and then reapplied due to battery
replacement or fuse replacement.