Starting and operating
NOTE
This device complies with Part 15 of
the FCC Rules and RSS-Gen of IC
Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
Parking your vehicle
& Parking brake
To set the parking brake, depress the
brake pedal firmly and hold it down until
the parking brake lever is fully pulled up.
7-29
CAUTION
Never drive while the parking brake
is set because this will cause unnecessary wear on the brake linings. Before starting to drive, always
make sure that the parking brake
has been fully released.
& Parking tips
To release the parking brake, pull the lever
up slightly, press the release button, then
lower the lever while keeping the button
pressed.
When the parking brake is set while the
engine is running, the brake system
warning light illuminates. After starting
the vehicle, be sure that the warning light
has turned off before the vehicle is driven.
Refer to “Brake system warning light” F320.
When parking your vehicle, always perform the following procedure.
. Apply the parking brake firmly.
. For MT models, put the shift lever in
the “1” (1st) position when on an upgrade
or the “R” (Reverse) position when on a
downgrade.
. For AT models, put the select lever in
the “P” (Park) position.
. When parking on a hill, always turn the
steering wheel as follows.
– CONTINUED –