Instruments and controls
NOTE
Some gate operators and garage door
openers may require you to replace
this programming step 4 with procedures in “Programming for entrance
gates and garage door openers in
Canada” F3-42.
1)
2)
3)
HomeLink® button 1
HomeLink® button 2
HomeLink® button 3
2. Press and hold the two outer
HomeLink® buttons (button 1 and button
3) until the indicator light begins to flash
(after approximately 20 seconds). Then
release both buttons.
3. Hold the end of the garage door
opener’s hand-held transmitter between
1 and 3 inches (25 and 76 mm) away from
the HomeLink® button you wish Ѽ