2-10
Keys and doors
& Sounding a panic alarm
A “PANIC” button is located on the back of
the transmitter.
To activate the alarm, press the “PANIC”
button once.
The horn will sound and the turn signal
lights will flash.
To deactivate the panic alarm, press any
button on the remote transmitter. Unless a
button on the remote is pressed, the alarm
will be deactivated after approximately 30
seconds.
& Selecting turn signal lights
operation
When the remote keyless entry system is
used, the turn signal lights flash. However,
the turn signal lights flashing operational/
non-operational setting can be changed.
Models with genuine SUBARU navigation system:
The setting can be changed using the
navigation monitor. For details, refer to the
Owner’s Manual Supplement for the navigation system.
Models without genuine SUBARU navigation system:
The setting can be changed by your
SUBARU dealer. Contact your SUBARU
dealer for details.
4. Open and close the driver’s door once
within 10 seconds after step 3.
5. The turn signal lights flash 3 times to
indicate completion of the setting.
& Selecting audible signal operation
& Replacing the battery
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock. If desired, you may turn
the audible signal off.
Do the following to deactivate the audible
signal. You can also use the same steps
to restore the function.
1. Sit in the driver’s seat and shut all
doors and the rear gate.
2. Hold down the UNLOCK side of the
power door locking switch.
3. While holding down the “UNLOCK”
side of the power door locking switch, pull
the key out and re-insert it into the ignition
switch at least 6 times within 10 seconds
after step 2.
You may have the above settings done by
your SUBARU dealer. Contact your
SUBARU dealer for details. For models
with a genuine SUBARU navigation system, the settings can be changed using
the navigation monitor. For details, refer to
the Owner’s Manual Supplement for the
navigation system.
CAUTION
. Do not let dust, oil or water get on
or in the transmitter when replacing the battery.
. Be careful not to damage the
printed circuit board in the transmitter when replacing the battery.
. Be careful not to allow children to
touch the battery and any removed parts; children could
swallow them.
. There is a danger of explosion if
an incorrect replacement battery
is used. Replace only with the
same or equivalent type of bat-