5-14
Audio
however, when radio signals are weak. In
such a situation, perform manual tuning to
select the desired station.
! Scan tuning (SCAN)
! PTY (Program type) group tuning
(only FM reception)
Type C audio:
PTY group up by
one step
Type A and B audio
Type A and B audio
PTY group down by
one step
Type C audio
This operation only changes the display. It
does not change the station that is
currently being received.
Type D audio
! Seek in PTY (Program type) group
(type A, B and C audio)
Type A and B audio:
Type C audio
Type D audio
If you press the “SCAN” button briefly
(type A, B and C audio)/continuously (type
D audio), the radio will switch to the scan
mode. In this mode, the radio scans
through the radio band until a station is
found. The radio will stop at the station for
5 seconds (type A, B and C audio)/10
seconds (type D audio) while displaying
the frequency, after which scanning will
continue until the entire band has been
scanned.
Press the “SCAN” button again to cancel
the SCAN mode and to stop at any
displayed channel.
Automatic tuning may not function properly if the station reception is weakened by
distance from the station or proximity to
tall buildings and hills.
Press the indicated button to change to
the PTY selection mode. At this time, the
PTY group that you are currently listening
to (type A, B and C audio)/that you
selected the last time (type D audio) will
be displayed for 10 seconds. In the PTY
selection mode, “PTY” is displayed on the
screen.
! PTY (Program type) group selection
In the PTY selection mode, press the
following button to change the PTY group
by one step at a time.
Seek up
Seek down
Type C audio:
Seek up
Type A and B audio:
PTY group up by
one step
PTY group down by
one step
Seek down