Subaru Forester Manuals 2011 Forester Owner’s Manual | Page 130

3-16 Instruments and controls & CHECK ENGINE warn- ing light/Malfunction indicator lamp CAUTION If the CHECK ENGINE light illuminates while you are driving, have your vehicle checked/repaired by your SUBARU dealer as soon as possible. Continued vehicle operation without having the emission control system checked and repaired as necessary could cause serious damage, which may not be covered by your vehicle’s warranty. If this light illuminates steadily or blinks while the engine is running, it may indicate that there is a problem or potential problem somewhere in the emission control system. ! If the light illuminates steadily If the light illuminates steadily while driving or does not turn off after the engine starts, an emission control system malfunction has been detected. You should have your vehicle checked by an authorized SUBARU dealer immediately. NOTE This light also illuminates when the fuel filler cap is not tightened until it clicks. If you have recently refueled your vehicle, the cause of the CHECK ENGINE warning light/malfunction indicator lamp coming on could be a loose or missing fuel filler cap. Remove the cap and retighten it until it clicks. Make sure nothing is interfering with the sealing of the cap. Tightening the cap will not make the CHECK ENGINE warning light turn off immediately. It may take several driving trips. If the light does not turn off, take your vehicle to your authorized SUBARU dealer immediately. ! If the light is blinking If the light is blinking while dr iving, an engine misfire condition has been detected which may damage the emission control system. To prevent serious damage to the emission control system, you should do the following. . Reduce vehicle speed. . Avoid hard acceleration. . Avoid steep uphill grades. . Reduce the amount of cargo, if possible. The CHECK ENGINE warning light may stop blinking and illuminate steadily after several driving trips. You should have your vehicle checked by an authorized SUBARU dealer immediately. & Coolant temperature low indicator light (if equipped)/Coolant temperature high warning light (if equipped) CAUTION . After turning the ignition switch to the “ON” position, if this indicator light/warning light behaves under any of the following conditions, the electrical system may be malfunctioning. Contact your SUBARU dealer immediately for an inspection. – It remains blinking in RED. – It remains illuminated in RED for more than 2 seconds. – It remains blinking in RED and BLUE alternately. . While driving, if this indicator light/warning light behaves under any of the following conditions, take the specified appropriate measure listed below. – Blinking or illuminated in