Audio
5-15
! Skip channel selection
! Category selection
! Channel scan
When in the SAT mode, press the “SEEK”
button “ ” or “ ” continuously to
change to the channel selection mode.
Pressing the “SEEK” button “ ” changes
the channel up by 10 steps each time.
Pressing “ ” changes the channel down
by 10 steps each time.
When in the SAT mode, press the “CAT”
button “ ” or “ ” to change to the
category search mode.
When in the category search mode,
pressing the “CAT” button “ ” changes
the category up by one step. Pressing “ ”
changes the category down by one step.
When a category is selected, turning the
“CH” dial selects channels only within the
selected category.
The control function returns to the normal
mode after approximately 10 seconds.
Press the “SCAN” button to change the
radio to the SCAN mode. In this mode,
under the selected category, the radio
scans through the channel until a station
is found. The radio will stop at the station
for 5 seconds while displaying the channel
number, after which scanning will continue
until the entire channel has been scanned
from the low end to the high end.
Press the “SCAN” button again to cancel
the SCAN mode and to stop on any
displayed channel.
– CONTINUED –