3-6
Instruments and controls
& Canceling the function for
meter/gauge needle movement upon turning on the
ignition switch
& Speedometer
The speedometer shows the vehicle
speed.
& Odometer/Trip meter
*: “ ” or “
” cannot be displayed when
the ignition switch is in the “ON” position.
To change the current setting, press the
trip knob for at least 2 seconds.
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the “ON”
position.
Turn the ignition switch to the “LOCK” or
“Acc” position.
Press the trip knob to show “ ” or “
”
on the odometer/trip meter display.
The display can be switched as shown in
the following illustration by pressing the
trip knob.
: Activated
: Deactivated
NOTE
. Your vehicle’s initial movement
setting of the meter/gauge needles
has been set for activation “ ” at the
time of shipment from the factory.
. It is not possible to cancel the initial
movement setting of the meter/gauge
needles when the ignition switch is in
the “ON” position. Cancel the setting
when the ignition switch is in the
“LOCK” or “Acc” position.
1)
Trip knob
This me