Vehicle Dynamics Control System 341 |
|||
|
namics Control is no guarantee that full vehicle control will be maintained at all times and under all conditions, its activation should be seen as a sign that the speed of the vehicle should be reduced considerably.
. Whenever suspension components, steering components, or an axle are removed from a vehicle equipped with the Vehicle Dynamics Control system, have an inspection of that system performed by an authorized SUBARU dealer.
. The following precautions should be observed in order to ensure that the Vehicle Dynamics Control system is operating properly.
– All four wheels should be fitted with tires of the same size, type, and brand. Furthermore, the amount of wear should be the same for all four tires.
– Keep the tire pressure at the proper level as shown on the tire inflation pressure label attached to the driver’ s side door pillar.
– When replacing a flat tire, use
|
only the specified temporary spare tire. However, even with the specified temporary spare tire, the effectiveness of the Vehicle Dynamics Control system will be reduced.
. If non-matching tires are used, the Vehicle Dynamics Control system may not operate correctly.
In the event of wheelspin and / or skidding on a slippery road surface and / or during cornering and / or an evasive maneuver, the Vehicle Dynamics Control system adjusts the engine’ s output and the wheels’ respective braking forces to help maintain traction and directional control.
. Traction Control Function
The traction control function is designed to prevent spinning of the driving wheels on slippery road surfaces, thereby helping to maintain traction and directional control. Activation of this function is indicated by flashing of the Vehicle Dynamics Control operation indicator light.
. Skid Suppression Function
The skid suppression function is designed to help maintain directional stability by suppressing the wheels’ tendency to slide sideways during steering operations. Activation
|
of this function is indicated by flashing of the Vehicle Dynamics Control operation indicator light.
NOTE
. The Vehicle Dynamics Control system may be considered normal when the following conditions occur. – Slight twitching of the brake pedal is felt. – The vehicle or steering wheel shakes to a small degree.
– An operating noise from the engine compartment is heard briefly when starting the engine and when driving off after starting the engine.
– The brake pedal seems to jolt when driving off after starting the engine.
. In the following circumstances, the vehicle may be less stable than it feels to the driver. The Vehicle Dynamics Control System may therefore operate. Such operation does not indicate a system malfunction. – On gravel-covered or rutted roads – On unfinished roads – When the vehicle is towing a trailer
|
7
Starting and Operating
|
– CONTINUED – |