298
Wireless Charger
tem is in operation, such as when opening and closing doors.
. In the following cases, the wireless charger will not operate normally: – You are in an area near a facility where electronic equipment is emitting strong radio waves, such as a power plant, broadcast station, or TV tower, or an electronic remote controller is being used nearby.
– The ambient temperature around the charging tray is high due to hot weather.
. If charging stops after a certain period of time, and the wireless charger does not operate normally, it may be due to any of the following reasons: – The mobile device is protruding from the charging area. – The mobile device is equipped with a large protruding camera.
– A thick object such as a case, cover, or accessory is between the charging surface of the portable device and the charging area.
– Two or more mobile devices are placed on the charging tray at the same time.
& Certification for the Wireless Charger s06bh02
. The U. S. and other FCC compliant countries
FCC ID: ACJ932AF2201 CAUTION
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a wireless power charger, pursuant to part 18 of the FCC Rules.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio communications, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency( RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator at least 20 cm or more away from person’ s body.
NOTE
This device complies with part 15 and part 18 of the FCC Rules. Operation is subject to the following two conditions:( 1) This device may not cause harmful interference, and( 2) this device must accept any interference received, including interference that may cause