Alarm System 137 |
|||||||||||
|
! Emergency disarming s02af0501
If you cannot disarm the system using the access key fob / transmitter( i. e., the transmitter is lost, broken or the transmitter battery is too weak), you can disarm the system without using the access key fob / remote transmitter.
The system can be disarmed if you turn the ignition switch from the“ LOCK”/“ OFF” position to the“ ON” position with a registered key / access key fob.
NOTE
For models with“ keyless access with push-button start system”, if the access key fob battery is discharged, perform the procedure described in“ Switching Power Status” FP447. In such a case, replace the battery immediately. Refer to“ Replacing Battery of Access Key Fob” FP503.
& Alarm System Setting s02af11
To change the setting of your vehicle’ s alarm system for activation or deactivation, do the following.
1. Disarm the alarm system. Refer to“ Disarming the System” FP136.
2. Sit in the driver’ s seat and shut all doors, the rear gate and engine hood.
|
3. Turn the ignition switch to the“ ON” position.
4. Hold down“” of the driver’ s power door locking switch, open the driver’ s door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows.
Setting status
Combination meter display( color LCD)
Horn
NOTE
You may have the above setting change done by your SUBARU dealer.
& If You Have Accidentally Triggered the Alarm System
s02af03
! To stop the alarm s02af0301
Do any of the following operations:
. Press any button on the access key fob / remote transmitter.
. Turn the ignition switch to the“ ON” position( models without“ keyless access with push-button start system”).
. Turn the push-button ignition to the“ ACC” position( models with“ keyless access with push-button start system”).
|
NOTE
Only registered keys will stop the alarm. If the immobilizer transponder is not registered, the alarm will not stop.
|
2
Keys and Doors
|