128
Remote Keyless Entry System
& Unlocking the Doors s02ae02
Press the“” button to unlock the driver’ s door and fuel filler lid. An electronic chirp will sound twice and the hazard warning flashers will flash twice. To unlock all the doors and the rear gate, briefly press the“” button again within 5 seconds.
NOTE
If the interval between the first and second presses of the“” button for unlocking all the doors is extremely short, the system may not respond.
& Opening the Rear Gate s02ae13
Press the“” button to unlock the rear gate. An electronic chirp will sound twice and the hazard warning flashers will flash twice.
This operation setting can be changed by a SUBARU dealer. Consult your SUBARU dealer for details.
& Setting Audible Signal Operation s02ae07
Using an electronic chirp, the system will give you an audible signal when the doors lock and unlock.
Models with“ keyless access with push-button start system”:
If desired, you can turn the audible signal off by operating the center information display. For details, refer to“ Car settings” FP204( 11.6-inch display models) or“ Vehicle setting icons” FP222( dual 7.0- inch display models). Furthermore, the volume setting of the audible signal can also be changed by a SUBARU dealer. Consult your SUBARU dealer for details.
Models without“ keyless access with push-button start system”:
Perform the following steps to deactivate the audible signal. Take the same steps to restore the function.
Steps |
Operation |
Time |
1 |
Sit in the driver’ s seat. |
— |
2 |
Close all doors. |
— |
( 1) |
Press and hold“
” on the power locking
|
|
|
switch. |
|
3
4
( 2)
Insert the key into the ignition switch and pull it out at least 6 times.
Open and close the driver’ s door.
Within 10 sec.
Within 10 sec.
The hazard warning flashers flash 3 times to indicate completion of the setting.
Your SUBARU dealer can perform the above procedure for you.
& Selecting Hazard Warning Flasher Operation s02ae26
Using the hazard warning flasher, the system will give you a visible signal when the doors are locked or unlocked. If desired, you can turn the hazard warning flashers off by operating the center information display. For details, refer to“ Car settings” FP204( 11.6-inch display models) or“ Vehicle setting icons” FP222( dual 7.0-inch display models). The setting can also be changed by a SUBARU dealer. Consult your SUBARU dealer for details.