46
Seatbelts
4 . Make sure that the “ ” mark on the anchor tongue plate and the “ ” mark on the anchor buckle face outwards .
3 . After drawing out the seatbelt , pass it through the belt guide as follows : First insert one edge of the belt into the open gap in the belt guide ; then slide the rest of the belt in , so that the whole belt fits inside .
5 . After confirming that the webbing is not twisted , insert the anchor tongue plate attached at the webbing end into the buckle on the right-hand side until a click is heard . . If the belt stops before reaching the buckle , return the belt slightly and pull it out more slowly .
. If the belt still cannot be unlocked , let the belt retract slightly after giving it a strong pull , then pull it out slowly again .
6 . Insert the center seatbelt tongue plate into the center seatbelt buckle until it clicks .
7 . To make the lap part tight , pull up on the shoulder belt . And place the lap belt as low as possible on your hips ,